Dulux Trade Anti Graffiti Clearcoat

Part 2 of a 2 part system. For use after primer on both previously painted and new surfaces
Size
Paint Calculator
This product is not for online sale and can only be purchased from selected stores.
Find a Store
Your Measurements:
Amount Needed:
For the best result we recommend to use {coatAmount} for {productTitle}
Key benefits
  • Extra Durability
  • Primed or previously coated surfaces
  • Interior & Exterior use
  • Water-based
Technical Information
  • Finish Matt
  • Coverage Up to 8m² per litre
  • Drying Time 6 hours at 20º
  • Recoatable Minimum 16 hours
  • Thinning Water 10
  • Composition Water-based
Product Features
  • Fantastic Dulux Quality

Product Description

Dulux Trade Anti Graffiti Clearcoat is a two part, water-based coating for use over existing sound coatings or clean, dry and laitance free uncoated masonry surfaces. Dulux Trade Anti Graffiti Clearcoat dries to a tough gloss finish that has good impact and abrasive properties, protecting areas that are prone to graffiti. Dulux Trade Anti Graffiti Clearcoat can be used in areas where low odour coatings are required such as hospitals, schools and public buildings.

Application Description

Application: Brush or roller only. For health and safety reasons this product must not under any circumstances be applied by spray. Mixing Ratio: Supplied in correct proportions. Add all of the Activator to this Base container and mix thoroughly for at least 5 minutes, until the product is smooth and even. Do not mix part units. Badly activated or incorrectly mixed materials will affect performance and may cause early failure or discolouration. Apply 1 or 2 coats of Dulux Trade Anti Graffiti Clearcoat to sound, clean surfaces. Avoid over-application. Note: Do not apply over underbound coating e.g. distemper or non cross-linked flexible coatings e.g. Acrylated Rubber or Chlorinated Rubber. It is recommended that a small test area is applied before treating the entire surface to ensure compatibility. The minimum recoat time is 16 hours, but must be recoated within 7 days. Pot Life; 1-2 hours (depending on prevailing conditions).

Technical & Safety Documentation

Tips & Advice

  • 1. Preparing the Surfaces
    To get the best results, ensure surfaces to be painted are sound, clean and dry (new surfaces particularly must be fully dry). See Dulux Trade Datasheet 816 for full information before use, available free on request by telephoning 0333 222 70 70 or visiting duluxtrade.co.uk. Before surface preparation read the Health & Safety information about old lead paints.
  • 2. Cleaning
    After use, remove as much paint as possible from equipment before cleaning with water
  • 3. Storing
    Do not use or store in extremes of temperature and protect from frost
Fetching the data, plz wait..