Cuprinol Garden Shades Tinting Base

Size
Paint Calculator
Find a Store
Your Measurements:
Amount Needed:
For the best result we recommend to use {coatAmount} for {productTitle}
Key benefits
  • 6 years protection
  • For use on all garden wood, terracotta, brick and stone
  • Beautiful matt colour enhances the grain of natural wood
  • Brush or spray
Technical characteristics
Technical Information
  • Finish Matt
  • Coverage Smooth planed wood -Brush 10-12m2 per litre ,Spray 4-5m2 per litre. Rough sawn wood - Brush 3-5m2 per litre ,Spray 2-3m2 per litre
  • Drying Time 1 hour
  • Composition Water-based
Product Features
  • 6 years protection

Product Description

Add beautiful colours to your garden with Cuprinol Garden Shades, which has been specially developed to colour, protect and weatherproof sheds, fences, garden furniture and other garden wood for upto 6 years. Its special pigments ensure a richer colour and allow the natural texture of the woodgrain to shine through. It can also be applied on terracotta,brick and stone. Colours are easy to choose by combining nature's neutrals (greys, and muted greens, browns and blues) which are best suited for bigger items in the garden and nature's brights (yellows, pinks, purples and brigther greens and blues) ideal for smaller items in the garden. Just have a go! Not to be applied on decking.

Application Description

Apply only in dry conditions, above 5 degrees Celsius and when bad weather is not forecast. Application by brush: Stir thoroughly before and during use. Brush on product evenly along the grain. Minimum 2 coats required.Application by spray: Stir thoroughly before pouring contents into a Cuprinol sprayer. Refer to the Sprayer user guide for full instructions before every use. Cover any nearby surfaces in case of overspray. Any overspray should be cleaned up immediately (whilst still wet) with water and household detergent.

Technical & Safety Documentation

  • CX_GB_EN_GARDEN_SHADES.pdf

Colour Range

Cuprinol Garden Shades

Tips & Advice

  • 1. Preparing the Surfaces
    All surfaces should be clean and dry. If it has been painted previously coated, loose flaking wood should be stripped back to bare wood. Test a small area first for colour and adhesion.The final colour will vary depending on the surface and the number of coats. If adhesion is inadequate on previous coatings, lightly sand before application. Make sure wood has been pre treated with appropriate wood preserver to prevent decay.
  • 2. Cleaning
    Remove product from brush with a cloth and then wash with water.
  • 3. Storing
    Do not store or use in extreme temperatures and protect from frost