Ensure product is thoroughly stirred before and during application, otherwise sheen and colour variations may be experienced.
Cetol TSI Satin plus is supplied ready for use and does not require thinning.
For best results use a good quality, long-haired soft bristle brush.
Three coats of Cetol TSI Satin plus should be applied, allowing a minimum of 16 hours drying time between coats. The product should be applied in a full flowing coat, laying off in the direction of the grain, using the minimum number of brushstrokes
necessary to produce an acceptable finish. Avoid overbrushing, as this will produce brush marks and a poor quality finish.
Apply to a minimum wet film thickness of 54 micrometres. Conditions – Do not apply when air/substrate temperatures are below 5ºC or above 30ºC during application or drying periods.Protect from water until dry. Failure to meet these requirements may adversely affect the drying, visual quality and durability of the finish.
The first coat should be carefully denibbed using a fine grade nylon abrasive pad or a fine grade (P240 or finer) wet or dry
silicon carbide abrasive paper, in the direction of the grain. Do not break through the surface coating. Remove all dust.
Subsequent coatings should be applied as soon as possible after the previous coat has dried, but no sooner than 16 hours.