Good to see you
Welcome to Dulux Trade
Terms and Conditions
Thanks! for registering
Successfully registered, please login
Registration complete
Forgotten your password?
Please enter email address associated to your account
Change Password
Password changed successfully.
Request sent!
Would you spare a minute to answer 3 questions
Registration complete
Successfully registered, please login
Delete Account

Dulux Trade Supermatt
-
High opacity
-
Ideal for new plaster
-
99.9% VOC Free (Based on in-can VOC content, measured in accordance with ISO 11890-2:2013.)
-
BREEAM NC 2018 & LEED v4.1 compliant
-
Finish Matt
-
Coverage Up to 18m² per litre
-
Drying Time Dependent on temperature and humidity
-
Recoatable 2-4 hours
-
Thinning Sealing new or bare surfaces- Add up to 1 part clean water to 3 parts paint Normal use- Add up to 1 part clean water to 4 parts paint Airless spray application- Add up to 1 part clean water to 10 parts paint.
-
Composition Water-based
-
Fantastic Dulux Quality
Product Description
* Based on in-can VOC content, measured in accordance with ISO 11890-2:2013.
** Independently tested for emissions, including formaldehyde, TVOC, TSVOC and Cat 1A & 1B carcinogens.
Application Description
To minimise picture framing or patchy finishes, we strongly recommend stirring the paint thoroughly prior to use. If thinned, the paint used for cutting-in and for rolling should be to the same ratio. Cut in one wall at a time, then rolling immediately afterwards, not allowing the cutting-in to dry prior to rolling. Cut in no more than 5 to 8cm away from any internal angles, including sockets/switches, skirting,
architraves, etc.
Seal new or bare surfaces with a thinned first coat of Dulux Trade Supermatt (up to 1 part clean water to 3 parts paint). The normal finishing process is 2 coats of Dulux Trade Supermatt (thinned up to 1 part clean water to 4 parts paint), however for significant colour change additional coats may be required. For best colour consistency, purchase sufficient tinted paint for each job at one time from the same source.
Technical & Safety Documentation
Colour Range
Tips & Advice
-
1. Preparing the SurfacesTo get the best results with Dulux Trade Supermatt, make sure surfaces to be painted are sound, clean, dry and free from all defective or poorly adhering material, dirt, grease and salts. Remove all loose and defective paint. Special precautions should be taken during surface preparation of pre-1960s paint surfaces over wood and metal as they may contain harmful lead. See Dulux Trade Datasheet 410 for full information before use, available free on request by telephoning 0333 222 7070 or visiting duluxtrade.co.uk. Before surface preparation, read the Health & Safety information about old lead paints.
-
2. CleaningAfter use, remove as much paint as possible from the equipment before cleaning with water
-
3. StoringDo not use or store in extremes of temperature and protect from frost
How much paint do I need?
More than one wall to paint? Try our advanced paint calculator
Measure the height and length of the surface you want to paint (in metres or centimetres).


Your Measurements:
{{!-- This value will be injected with JavaScript --}}
Amount needed:
{{!-- This value will be injected with JavaScript --}}
This is an estimated based on 2 coats. Actual coverage will depend on the conditions of the surface. If the colour change is strong, more coats may be required.
Add a new job
Add a new job
Edit job
Delete job
Are you sure? All notes, photos and saved items will be deleted.
Save Color
Save to My Workspace
Add to job

Dulux Trade Supermatt
Save to My Workspace