Dulux Trade Blockfiller Plus

Size
Paint Calculator
Find a Store
Your Measurements:
Amount Needed:
For the best result we recommend to use {coatAmount} for {productTitle}
Key benefits
  • Excellent filling properties
  • For use on concrete surfaces
  • Water-based
Product Features
  • Fantastic Dulux Quality
Technical Information
  • Finish Matt
  • Coverage Up to 5m² per litre
  • Drying Time 1 hour
  • Recoatable 4 hours
  • Composition Water-based

Product Description

Dulux Trade Blockfiller Plus is a water-based product, which is suitable for interior use on concrete walls and ceilings. Designed to fill surface imperfections in concrete block and poured concrete, to improve the appearance of the substrate. It can act as a finish or a primer for subsequent Dulux Trade finishes. Ideal where minimum downtime and efficiency is required. Caution: This product is designed only for the purpose of filling voids and pores within the surface of the concrete. Topcoats applied over excessive build-up of the Dulux Trade Blockfiller Plus can cause delamination of the filler, resulting in peeling of the topcoat.

Application Description

Application: Apply a generous coat by airless spray followed immediately by tipping off with a medium pile roller. For airless spray application, we recommend a minimum working pressure of 140 kg/cm² (2000 Ib/sq in) with a spray tip size of 19 thou and a fan of 12 inches. May also be applied by brush, roller or conventional spray. When applying by spray, work into all pores and voids with the first pass, then finish with a full coat. If applying by brush, remove brush marks with a partially loaded roller while the filler is still wet. Do not apply if the surface temperature is below 10°C. STIR THOROUGHLY BEFORE USE. Do not thin. Concrete Block and Poured Concrete: After surface preparation, apply one coat of Dulux Trade Blockfiller Plus, which can be left untopcoated or finished with an appropriate Dulux Trade paint system. Previously Painted Surfaces: Not suitable for application to previously painted surfaces, unless the surface contains voids and pores large enough to allow application of this filler without excessive surface build.

Technical & Safety Documentation

  • Dulux Trade Blockfiller + tds.pdf
  • dt_gb_en_block_filler_plus.pdf

Tips & Advice

  • 1. Preparing the Surfaces
    To get the best results, ensure surfaces to be painted are clean, dry and free from all defective or poorly adhering material, dirt, grease and salts. See Dulux Trade Datasheet 448 for full information before use, available free on request by telephoning 0333 222 70 70 or visiting duluxtrade.co.uk. Before surface preparation, read the Health & Safety information about old lead paints.
  • 2. Cleaning
    After use, remove as much product as possible from equipment before cleaning with water
  • 3. Storing
    Do not use or store in extremes of temperature and protect from frost