Cuprinol All Purpose Wood Filler

Size
Find a Store
Your Measurements:
Amount Needed:
For the best result we recommend to use {coatAmount} for {productTitle}
Key benefits
  • Formulated to flex with the natural movement of the wood
  • Can be sanded when dry
  • Can be painted, stained or varnished
  • Non flammable
  • Suitable for both interior and exterior use
  • Solvent free, low odour
Product Features
  • Can be sanded when dry
  • Can be painted,stained or varnished
  • Non flammable
  • Formulated to flex with the natural movement of the wood
  • Interior and Exterior
  • Solvent free,low odour
Technical Information
  • Drying Time Approximately 2 hours
  • Recoatable Approximately 2 hours

Product Description

Cuprinol All Purpose Wood Filler is a tough, durable wood filler for small repairs. Specifically formulated to flex with the natural movement of the wood. It can be sanded, painted, stained or varnished when dry. It is not suitable for gaps between floor boards. It is easier and more pleasant to use because of its solvent free and low odour non flamable formulation.

Application Description

Ensure surfaces are clean and dry. Knead tube to mix contents. Apply using a wet filling knife, or using the cartridge, apply along or in the repair area, smoothing with a wet knife where necessary, leaving the filler slightly proud for sanding. For deep holes build up in layers, allowing each layer to dry. Leave proud and when completely dry (normally 2 hours) sand down and dust off. Tub: Stir well before use. Apply using a wet filling knife. For deep holes build in layers, allowing each layer to dry. Leave proud and when completely dry (normally 2 hours) sand down and dust off. Finish with stain, varnish or paint. When over painted, stained or varnished the filled area may differ in colour to the surrounding area; therefore we recommend filling and finishing a small test area first to ensure that the appearance is acceptable. Do not use with wood dye. Cartridge: Apply along or in the repair area, smoothing with a wet knife where necessary, leaving the filler slightly proud for sanding. For deep holes (greater than 5mm deep) build up in layers, allowing each layer to dry. Leave proud and when completely dry (normally 2 hours) sand down and dust off. Finish with stain, varnish or paint. When over painted, stained or varnished the filled area may differ in colour to the surrounding area; therefore we recommend filling and finishing a small test area first to ensure that the appearance is acceptable. Do not use with wood dye. For breaks in between filling release trigger on cartridge gun to avoid overspill.To get the best results with Cuprinol All Purpose Wood Filler, make sure surfaces to be filled are sound, clean and dry (new surfaces particularly must be fully dry).

Technical & Safety Documentation

  • CX_GB_EN_ALL_PURPOSE_WOOD_FILLER.pdf

Tips & Advice

  • 1. Preparing the Surfaces
    To get the best results make sure the surfaces to be painted are sound, clean and dry.New surfaces in particular must be fully dry
  • 2. Cleaning
    After use, remove as much product as possible from application equipment, before cleaning with cellulose thinners